2001 Carver 570 Voyager

Description

Fresh out of Safe Harbor Boat Yard (4/11/24) with over 30k of regularly scheduled maintenance and repairs. Love On The Docks is ready for her new owner to make her their own. The summer awaits for many days of enjoyment ahead. 

New bottom paint. Hydro washed, Wet sanded with 60 grit, feathered and the base built up with high-build epoxy primer.  Strip underwater metals to bare metal (struts, trim tabs,  thru-hulls). Strip underwater metals to bare metal (struts, trim tabs,  thru-hulls)Apply anticorrosive/barrier epoxy prime coats to bare metal. Apply two-coats of Trinidad HD bottom paint to the entire bottom and three coats to the waterline,  leading edge, hardware and all high-wear areas.

• New cutless bearings
• New Trim tabs
• New underwater lights
• Replace 1 1/2" AC feed through hull, valve, and nipple 90 degrees.
• Replace1 trim tab actuator.
• Replace 2 ea. trim tab plates 12' x 54.
• Prep new actuator.
• Install new nipple and install actuator. Install new 90 degree.
• Replace transom zinc bolts with silica all-thread studs.
• Connect to the existing bonding system.
• Remove generator intake through hull.
• Remove plumbing for generator through hull.
• Install new generator through hull, valve, nipple and backing block 1".
• Install plumbing on generator through hull.
• Remove through hull and scoop.
• Install through hull for A/C feed.
• Plumb A/C through hull.
• Remove 1" through hull, valve and redirect for live well feed.
• Install 1" through hull.
• Plumb livewell pump to through hull, reconnect connectors.
• Replace shaft lip seals in port and starboard shafts.
• Remove propellers.
• Remove coupler bolts to facilitate shaft removal.
• Remove the king nut from the shaft coupler and remove shafts.
• Remove shaft seal and replace with new seal housings and spare carriers Port and Stbd.
• Reinstall shafts.
• Replace cutlass bearings.
• Replace rudder seal housings by way of rudder removal.
• Remove tiller arms.
• Block rudders.
• Remove and replace housings for rudder seals.
• Reinstall rudders and tiller arms.
• Replace generator exhaust discharge through hull for water out. 
• Remove generator water through hull.
• Prep generator water out through hull.
• Install new generator out through hull, valve, nipple and backing block.
• Plumb generator water out through hull.
• 4 New rudder zincs.

ELECTRONICS

4" Richie Compass

Furuno Navnet GPS/ Radar

Standard Horizon RAM mic vhf

Robertson AP-20 auto pilot Standard Horizon Depth meter

 

NAVIGATION ELECTRONICS, PILOTHOUSE

Furuno Navnet GPS/ Radar

Robertson AP-22 auto pilot

Standard Horizon Spectrum vhf

Standard Horizon depth meter

North Star 962 GPS chart plotter

Richie 4" compass

 

ELECTRICAL EQUIPMENT

Onan 12.5 kW diesel generator with sound shield @ 200 hours

Glenndinning shore power cable system, 50' of 50 amp cable Spare 50' 50 amp cable

(6) 8D lead acid batteries

(2) Charles battery chargers

Vanner 2500 watt inverter

 

MECHANICAL EQUIPMENT

Volvo 12-D 675 HP diesel main engines with 400 hours

QL bow thruster

(2) Cruise Air 24,000 BTU air conditioners in salon and pilothouse

(1) Marine Air 12,000 BTU air conditioner in VIP and guest staterooms

(1) Aqua Air 12,000 BTU air conditioner in master stateroom

Fire Boy Fire Suppression System Fire Extinguishers

18 gallon Seaward hot water heater Vacuflush head system

Engine room camera

New Turbos on Each Main (2023)

Genset Fully Serviced

Fuel System Service Performed

New Fresh Water Pump

 

DECK EQUIPMENT

The hull's bottom was painted in April, 2016 and Petit anti fouling paint was applied to the props at that time. Stainless steel bow pulpit, life rail and handrails

Maxwell 12V electric windlass with helm controls and foot pad controls at windlass

Stainless steel Delta anchor and 150' chain

Anchor wash down in foredeck locker

Foredeck cushions with cover

600 lb. davit for tender on flybridge

Large integral swim platform with swim ladder

Transom shower

Shore water connector

Cable and telephone connectors

PDF's, lines and fenders

New upholstery on all the seat with a nice large table

The helm station has duplicate electronic instruments, gauges and controls of the lower helm

Aft of the enclosure are chocks for the tender and the dinghy davit which can lift 600 pounds.

GALLEY and LAUNDRY

Three burner Princess stove

Full wall oven

Microwave Convection Oven

Double sink

Cherry cabinets

Black Corian countertops Coffee Maker

Trash compactor

Washer and dryer units

 

 

REMARKS

This Carver 570 Voyager Pilothouse is in excellent condition and is a perfect yacht for your Catalina run or cruising the bay with friends and  family.

Equipped with the upgrade 675 HP Volvos D-12 with low hours (approx. 400 hrs), she has a bow thruster and 11’ tender.

The roomy fly bridge offers generous seating, including two double-wide lounges and a wraparound portside lounge that seats seven. There's also a beautifully designed control console and aft of bridge storage for a tender. The large cockpit provides overhead sun and weather protection, plus convenient side deck stairways and a sliding glass door leading to the  cabin.

Accommodations

A super-popular model for Carver with distinctive lines and spacious accommodations, the 570 Voyager is a stretched version of then Carver 530 Voyager with the extra length going into the enlarged salon and galley. The three stateroom cherry wood interior is arranged with the galley forward in the very spacious salon with its long L-shaped sofa to starboard and club chairs opposite. A breakfast bar is built into the galley counter and large windows together with nearly seven feet of headroom combine to create an unusually open and airy salon.

Upon entering the salon from the aft cockpit thru the sliding glass doors, the salon spans the full width of the boat has plenty of comfortable seating, great views through the large side windows and excellent headroom.

The full galley is located forward of the salon and features black granite flooring, Princess electric stove and oven, microwave, GE refrigerator, Subzero freezer, double sink, Broan trash compactor, ample storage and bi-level black granite counter tops.

A main attraction of the 570 is the roomy pilothouse with L-Shaped leather sofa, wrap around helm console and plush Captain’s chair. The flybridge offers two double wide lounges and a wrap around portside lounge that seats  seven.

Stairs from the pilothouse lead down and forward to the three staterooms. The full width master is located amidships and has its an ensuite head with separate toilet and head compartments. The full size washer and dryer are located in the master stateroom as well. There is plenty of storage throughout the boat.

Next forward to the port side is the guest cabin with bunk beds. The guest head and shower is located across the hall. The VIP stateroom is located forward with a walk around queen berth, closet, television, overhead hatch and  excellent lighting.  The engine room is reached through the lazarette.

Disclaimer
The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.